Titebond 510332 - 19L II Premium Wood Glue

Weatherproof bond suitable for wood-to-wood bond where moisture is present. A shelf-stable, one-part (pre-catalysed) cross-linking PVA adhesive. It is recommended for high frequency and hot or cold press, edge and face gluing and finger joint applications. With its very fast setting rate, viscosity stability and high percentage solids, Titebond Premium II can also be used for a variety of assembly gluing applications. It develops a DIN EN 204 D3 water-resistant bond with a light-coloured glue line. Ideal for making block chopping boards it is approved for indirect food contact by FDA USA.

Features:

• First one-part wood glue to pass ANSI Type II water-resistance ( passes the soak test)
• Minimal joint creep
• Designed for exterior use
• Excellent standability
• Unaffected by finishes
• FDA approved for indirect food contact
• Ideal for radio frequency (R-F) and hot press gluing systems
• Easy cleanup with water

Specifications:

• Type: Cross-linking polyvinyl acetate
• State: Liquid
• Colour: Honey Cream
• Dried film: Translucent Yellow
• Solids: 48%
• Viscosity: 4,000 cps
• Storage life: 24 months in tightly closed containers at 24°C
• Calculated VOC: 3.0g/L
• Weight per gallon: 4.17kg
• Chalk temperature: Approximately 13°C
• Flashpoint: >93°C
• Freeze/thaw stability: Stable
• pH: 3.0

Application Guidelines:

• Application Temperature: Above 13°C.
• Open Assembly Time: 3-5 minutes (21°C./50%RH)
• Total Assembly Time: 10-15 minutes (21°C./50%RH)
• Minimum Required Spread: Approximately 6 square meters per litre
• Required Pressure Application: Enough to bring joints tightly together (generally, 100-150 psi for softwoods, 125-175 psi for medium woods and 175-250 psi for hardwoods)
• Method of Application: Plastic bottles for fine applications; glue may also be spread with a roller spreader or brush.
• Cleanup: Damp the cloth while the glue is wet. Scrape off and sand-dried excess.

Titebond II Premium Wood Glue is not for continuous submersion or for use below the waterline. Not for structural or load-bearing applications. Do not use when temperature, glue or materials are below 12.7°C. Due to low pH, the product may cause corrosion on metal surfaces, test the product before using where rusting/corrosion may be of concern. Freezing may not affect the function of the product but may cause it to thicken. Agitation should restore the product to its original form. Because of variances in the surfaces of treated lumber, it is a good idea to test for adhesion. For best results gluing exotic or oily woods, such as Ipe and Teak, please contact our Technical Support Team at 1-800-347-4583. Read MSDS before use. KEEP FROM FREEZING. KEEP OUT OF THE REACH OF CHILDREN.

CAUTION: EYE AND SKIN IRRITANT. Contains aluminium chloride. Do not swallow. Do not allow eye contact or prolonged skin contact. FIRST AID: If swallowed, do not induce vomiting; contact a physician. If eye contact occurs, flush with water for 15 minutes. Wash skin contact areas with soap and water. If irritation from eye or skin contact persists, contact a physician. For additional information, refer to the Safety Data Sheet. KEEP OUT OF THE REACH OF CHILDREN.